BORA Professional 3.0: Insufficient Extraction and Filter Error

⚠️ SAFETY WARNING / SERIOUS RISK. This appliance operates with critically dangerous components (High Voltage or Gas). DIY repair of critical devices can be fatal and is prohibited by law. Physical intervention legally requires qualified specialized technicians to issue compliant safety certificates. ReeFix provides this diagnosis EXCLUSIVELY for educational and informational purposes.

Quick Diagnosis BORA Professional 3.0: Extraction and Filter

The report of insufficient extraction and the filter error on the BORA Professional 3.0 indicate with high probability (approximately 75%) a saturation of the filtering system and/or a failure to reset the operating hours counter.

Essential Checks:

1. Software Reset: Access the configuration menu via the knob and attempt the "Filter Service Reset". Often, the error persists even with new filters if the counter has not been reset. This is a typical user error.
2. Grease Filter: Check and thoroughly clean the BORA Professional 3.0 Stainless Steel Grease Filter.
3. Activated Carbon Filter: If the system is recirculation, a saturated BORA Professional 3.0 Activated Carbon Filter is the most common cause of reduced extraction. Its replacement is periodic maintenance.

Operational Decision: Attempt software reset and filter maintenance/replacement (low cost, safe DIY intervention). If the problem persists, or if extraction remains insufficient (15-10% probability), the fault could lie in Ecotube duct obstructions or malfunctions of the damper servomotor/EC motor. In these cases, contact a qualified technician for an in-depth diagnosis and interventions on critical components. Replacement of the entire device is rarely necessary for these initial problems.